To.Rage Axle Bash Nut

This is a tool to help with removal of T1, T2, T3, 955, 957, 958 axles from the wheel bearings where they tend to be stuck to the bearing or hub splines, while protecting the threads from hammer damage. 
At the beginning of the threads are some grooves to allow any minor amounts of dirt to be cleaned out of the axle nut threads. This is not intended to repair damaged threads. apply WD40 or other light oil prior to installing. ALWAYS USE LUBE!
Remove the original axle nut, lubricate the threads, install the bash nut, and drive the axle through the wheel bearing with either a BFH or an air hammer. 
After many uses you should remove any edge mushrooming of the hammered surface by grinding it off for safety.